If you want to set python2 as default python actuators, repeat above steps and just change the third command
to the following.
sudo ln -s python2 python
We will execute a same python file Hello.py with Python2 and Python3.
First, use Python2 to execute the code.
1. Use cd command to enter 00.0.0_Hello directory of Python code.
cd ~/Freenove_Ultimate_Starter_Kit_for_Raspberry_Pi/Code/Python_Code/00.0.0_Hello
2. Use python2 command to execute python code Hello.py.
python2 Hello.py
Use Python3 to execute the code under same directory.
3. Use python3 command to execute python code Hello.py.
python3 Hello.py
As you can see, we get same results.
Because the code for our kit supports Python2 and Python3. We just say python later, not specific Python2 or
Python3. You can shoose python version according to your situation.
To Next Page
Loading...
Need help?
General