Project 2.2 MINI table lamp
We will also use a button, LED and UNO to make a MINI table lamp. But the function is different: Press the
button, the LED will be turned on, and press the button again, the LED goes out.
First, let us learn some knowledge about the button.
Debounce for Push Button
When a Push Button is pressed, it will not change from one state to another state immediately. Due to
mechanical vibration, there will be a continuous buffeting before it becomes another state. And the releasing-
situation is similar with that process.
Therefore, if we directly detect the state of Push Button, there may be multiple pressing and releasing action
in one pressing process. The buffeting will mislead the high-speed operation of the microcontroller to cause
a lot of false judgments. So we need to eliminate the impact of buffeting. Our solution is: to judge the state
of the button several times. Only when the button state is stable after a period of time, can it indicate that the
button is pressed down.
This project needs the same components and circuits with the last section.
To Next Page
Loading...
Need help?
General