FreeWave FGR2-PE - Page 15

LUM0024AB Rev A
Preface
This document includes the following regarding your FreeWave FGR2-PE transceiver:
l An introduction to the transceiver, its ports and LEDs, and how to determine the mode you want to
run it in.
l Basic programming information including the interfaces you can use to program the transceiver,
determining a transceiver's IPaddress, and setting up permissions to access the transceiver
setup information, and how to perform firmware upgrades.
l Descriptions of each parameter available when defining IP information, serial port setup, general
transceiver setup, SNMP information, and security.
l Descriptions of each statistic that is available about the transceivers state and performance.
l Examples of how FreeWave transceivers can exist in a network with other transceivers.
l Pin outs, specifications, and other mechanical information.
l Information additional tools you might use when working with your Plus-style transceiver.
For information about the firmware releases that apply to the transceiver, see Appendix A.
Notational Conventions
This guide uses the following notational conventions:
l Bold - Indicates items that you select, parameter settings, and parameter names.
l
Warning! - Indicates a situation that might cause damage to your radio, your data, or your
network.
l
- Provides time saving or informative suggestions about using the product.
xv