User Manual and Reference Guide
LUM0024AB Rev A
FGR2-PE Specifications
Specification
Frequency Range 902 to 928 MHz (FHSS)
Transmitter
Output Power 5 mW to 1 W
Range—Line-of-Sight Point-to-Point: 60 miles, Point-to-Multipoint: 60 miles
Modulation 2 level GFSK
Occupied Bandwidth 230.4 kHz
Hopping Patterns 15 per band, 105 user selectable
Hopping Channels 112
Frequency Zones 16 zones, 7-8 channels per zone
RF Connector TNC
Receiver
Sensitivity -110 dBm for 10
-4
bit error rate at 115 Kbps
-106 dBm for 10
-4
bit error rate at 153.6 Kbps
Selectivity 20 dB at fc ± 230 kHz
System Gain 140 dB
Data Transmission
Error detection 32 Bit CRC, retransmit on error
Data encryption 128-bit AES encryption, proprietary 256-bit Dynamic Key Substitution, SSL
Authentication RADIUS, HTTP Password
Data interface Ethernet: EIA-232/485/422
Protocol Ethernet: IEEE 802.3 TCP/IP, DHCP, ICMP, UDP, ARP, Multicast, TCP
Data Connector Ethernet: 2x 10/100 Base T, Auto Crossover and 2x Serial, RJ45
Power Requirements
Operating Voltage +6 to +30 VDC
Current
Mode 6 VDC 12 VDC 30 VDC
Transmit 1.1 A 550 mA 220 mA
Receive 252 mA 150 mA 63 mA
Idle 140 mA 71 mA 32 mA
General Information
99
To Next Page
Loading...
