Frigidaire FAHE4044MW0 - Diagnostic Mode Tests

64
SECTION 6 - PUSH BUTTON SELECTION WASHER TECHNICAL DATA
MODE
NUMBER
CYCLE SELEC-
TOR POSITION
14 CYCLE
WASHER
TEST
pre-test 12 O’Clock
p
osition 0
At “position 0” chime will beep and status LED’s and digital display will blink repeatedly.
1.
one click
clockwise from
12 O’Clock
p
osition 1
Turn the cycle selector knob one click away from 12 O’Clock position. The lid lock will
activate and the hot water solenoid will activate and hot water should enter the tub.
2.
two clicks
clockwise from
12 O’Clock
p
osition 2
Turn the cycle selector knob two clicks away from 12 O’Clock position. The cold water
solenoid will activate and cold water should enter the tub. If unit is equipped with fabric
softener option, the softener dispenser solenoid will activate the softener chamber will
fi ll up cold water as it siphons.
3.
three clicks
clockwise from
12 O’Clock
p
osition 3
Turn the cycle selector knob three clicks away from 12 O’Clock position. The lid lock will
deactivate and the lid can be opened. The tub light (if equipped) will activate.
4.
four clicks
clockwise from
12 O’Clock
p
osition 4
Turn the cycle selector knob four clicks away from 12 O’Clock position. The lid lock will
activate and both the hot and cold water solenoids will activate fi ll the tub to a certain
level. After the pressure sensor has been satisfi ed, agitation will begin and the recircu-
lation pump (if equipped) will turn on.
5.
fi ve clicks
clockwise from
12 O’Clock
p
osition 5
Turn the cycle selector knob fi ve clicks away from 12 O’Clock position. All motor move-
ment will stop, and only the drain pump will activate, draining out any water in the tub.
6.
six clicks
clockwise from
12 O’Clock
p
osition 6
Turn the cycle selector knob six clicks away from 12 O’Clock position. The drain pump
turns on and the washer goes to high spin. Spin should always happen in the counter-
clockwise direction of the tub.
7.
seven clicks
clockwise from
12 O’Clock
p
osition 7
Turn the cycle selector knob seven clicks away from 12 O’Clock position. The control
will signal the last 5 error codes and software version with “00” being no error. Refer to
section “Read Error Codes” and “Error Code Chart”.
IMPORTANT
All of the tests listed below should be performed with an empty tub. No balancing algorithms are
performed by the motor control board, so anything left in the tub will cause a serious out-of-
balance situation and potential damage to the washer as it reaches higher spin speeds.
Diagnostic Mode Tests
6 - 12