3. GENERAL SAFETY STANDARDS
Strictly observe the general safety and accident-prevention standards listed hereafter:
- This machine is not intended to be used by children orpersons with limited physical,
sensorial and intellectual faculties or lacking experience and/or knowledge unless they
are monitored by a person in charge of their safety or receive instructions concerning use
of the machine. Children must be supervised to avoid them playing with the machine.
- Children must be supervised to avoid them playing with the machine.
- Use of the machine is reserved for operators only, who have read, understood and
acknowledged all that is included in this manual.
- It is forbidden to remove or tamper with the safety systems installed on the machine.
- While the appliance is operating, it is mandatory to check that danger situations for
persons do not occur. Should these conditions occur, stop the appliance immediately.
- When you have finished working with the machine, it is mandatory to cut power by acting
on the master switch.
- When unusual noise or anomalous functioning is perceived, it is mandatory to
immediately stop operations in progress and to search for the cause of these
irregularities. If in doubt, avoid improper operations by contacting the technical
assistance service of the manufacturer.
- Any tampering or modification of the machine automatically entails the immediate
termination of the warranty and relieves the manufacturer of all and any liability for direct
or indirect damage caused.
- During loading, unloading and handling operations, it is mandatory to use equipment with
a capacity adequate for the mass (weight) of the machine, using hoisting devices and
accessories with features and state of use suitable for the purpose.
- If fire-prevention equipment is necessary use types which are compatible with the
presence of voltage on board.
- It is forbidden to wear long and loose apparel, ties, jewellery, scarves or similar clothing
which could get caught in the moving parts of the machine. Hair must be tied back and
shirt-sleeves tight.
- The machine will not eventually compensate and correct for any errors during the setup
or filling operations. Thus, the initial assembly and priming
procedures are of extreme importance. It is strongly recommended that personnel
responsible for the machine's operation, both assembly and disassembly, go through
these procedures together in order to be properly trained and to prevent
misunderstandings. In the event you should require technical assistance, please contact
your local authorized Distributor.
- In case of doubts regarding the operation, use, maintenance and any other aspect
concerning the safety of the equipment, contact the authorized technical assistance.
To Next Page
Loading...
