Froling TX 200 - Blowing in Fuel for a Partially Emptied Store with Rotary Agitator; Blowing in Pellets for a Store with Pellet Screw

❒
Load a small quantity of wood chips and wait until the arms / spring blades are
touching the head of the rotary agitator (approx. 2 revolutions)
❒ Only then should you load the remaining material
3.2.3 Blowing in pellets for a store with pellet screw
❒ Switch off the boiler by tapping “Boiler off” at the mode icon and allow to cool for at
least two hours
❒
Close all openings to the store to seal out dust
❒ Blow the fuel into the store
3.2.4 Blowing in fuel for a partially emptied store with rotary agitator
If there is still sufficient fuel in the store (the head of the rotary agitator is completely
covered with fuel and the rotary agitator arms are not extended), the store can be filled
as follows:
❒
Switch off the boiler by tapping “Boiler off” at the mode icon and allow to cool for at
least two hours
❒ Close all openings to the store to seal out dust
❒ Blow the fuel into the store
3
Operating the System
Filling/refilling the store with fuel
24 Froling GesmbH | A-4710 Grieskirchen, Industriestraße 12 | www.froeling.com