3.3 Heating up the boiler
NOTICE
Do not modify the factory settings!
Changing the system's factory settings can be detrimental to efficiency and
emissions of the system.
3.3.1 Switching on the power supply
❒ Turn on the main switch
➥ There is voltage at all of the boiler's components
➥ When the control has completed the system start, the boiler is ready for
operation
3.3.2 Switching on the boiler
❒ Switch the boiler on by tapping “Boiler ON”
➥ Automatic mode is active
➥ The heating system is controlled via the controller according to the selected
mode in automatic mode
❒
For other modes press the relevant function key
➥ Information on function keys in the relevant operating instructions of the boiler
controller
3.3.3 Regulating the boiler
Please see the relevant operating instructions for the "Lambdatronic H 3200 TX" boiler
controller for the necessary control steps, as well as displaying and modifying
parameters
3.3.4 Switching off the boiler
❒ Switch boiler off by tapping “Boiler OFF”
➥ The boiler follows the shutdown program and switches to "
Boiler off" status
➥ The combustion unit is switched off, the chamber discharge unit and the entire
hydraulic system remain active
3
Operating the System
Heating up the boiler
26 Froling GesmbH | A-4710 Grieskirchen, Industriestraße 12 | www.froeling.com
To Next Page
Loading...
