Fromm AP100 - MACHINES TECHNICAL SPECIFICATIONS; PACKAGING; UNPACKING

10
Copying all or part of this manual in any way or form is strictly prohibited without written permission from its author © 2015
website: www.fromm-pack.com
12 MACHINES TECHNICAL SPECIFICATIONS
Machine
Dimensions
Width
470 mm
Length
440 mm
Height (without film roll)
379 mm
Weight
Total weight (without film roll)
approx. 11,4 kg
Conditions
Operating temperature
+ 5 to +30
o
C
Operating environment
clean, dry
Electricity
Power supply
90-240 V 50/60Hz
Rated power
0.2 kVA
Power used
approx. 0.1 kW
Film
Film width
max. 200 mm
Film type
PE/PE - PE/PA
Film thickness
20 - 35 µm
Film roll dimensions
int.Ø 76 mm
ext.Ø 280 mm max.
CAUTION: do not use film that has not been supplied by FROMM, or that is of a different thickness than
specified without contacting the manufacturer.
13 PACKAGING
The machine is generally shipped in a cardboard box.
The package contents is covered:
- with a barrier bag in low-density polyethylene (LPDE), which is heat-sealed in the event of sea transport;
- with cling film for all other types of transport.
- In both cases, filling materials are added.
In accordance with UNI 9151/3, the packaging contains enough silica gel desiccant to keep moisture levels below
35% during the estimated transport time (unless otherwise agreed).
Note: Boxes can be stacked only 4 high!
14 UNPACKING
UNPACKING AND INSPECTION UPON RECEIPT
Upon receipt, inspect the packaging to ensure that it has not been damaged or tampered with.
THE TRANSPORTER AND MANUFACTURER SHOULD BE NOTIFIED OF ANY DAMAGE TO THE MACHINE
OBSERVED UPON RECEIPT.
Opening the packaging
- Open the cover of the box.
- Remove the filling material.
- Remove the desiccant, if present.
- Ensure that no small machine parts remain in the box.
- Perform a detailed inspection of the general conditions.