15
Copying all or part of this manual in any way or form is strictly prohibited without written permission from its author © 2015
website: www.fromm-pack.com
21 STARTING THE MACHINE
21.1 Power on
The machine is turned on using a switch found on the rear of the machine. The electronics start up and the display is
illuminated. Data is loaded in a few minutes and the machine is then ready for use.
The machine will start in automatic mode according to the operating mode selected. The machine may only be started
in automatic mode.
21.2 STOPPING THE MACHINE
The machine features an on/off switch.
The machine may also be shutdown under any of the following conditions:
- a. Using the stop button .
- b. After an alarm.
- c. When the pillow basket is overfilled (if installed).
- d. When the number of meters selected in the program has been reached.
- e. By the optical sensor on the front of the machine.
In the abovementioned cases, it may be necessary to perform an action to restart the machine or to satisfy a specific
condition:
- a. Press the start button .
- b. Eliminate the error and press start.
- c. The machine starts in automatic mode when the sensor on the machine allows it.
- d. The machine starts when the start button is pressed.
To Next Page
Loading...