5
Copying all or part of this manual in any way or form is strictly prohibited without written permission from its author © 2015
website: www.fromm-pack.com
3 INTRODUCTION
The AP100 machine was designed and manufactured pursuant to the European Community Directive 2006/42/EEC.
This document contains use and maintenance instructions, which must be carefully followed in order to obtain the best
production results and to maintain the initial dependability of your machine; in particular, it is recommended that you
avoid making any adjustments not indicated in this manual, as this may compromise the safety and reliability of the
machine.
Spare parts must be ordered directly from an authorized supplier.
FROMM is always available to provide you with assistance and reminds you that failure to comply with the information
provided in this document shall immediately void your machine warranty.
To correctly use the machine, it is important to know the basic definitions used to assess risk, and how this machine
was designed for safety:
A potential source of personal injury or bodily harm.
Any area inside and/or near a machine in which the presence of a person represents a
risk for the safety and health of the person in question.
Any person who finds him or herself fully or partially inside a hazard area.
The person(s) in charge of installing, operating, adjusting, cleaning, repairing and
moving a machine, or of performing machine maintenance.
A combination of the probability and seriousness of personal injury or bodily harm that
may occur in a hazardous situation.
A machine component designed specifically to provide protection using a physical
barrier.
A device (other than a guard) that reduces risk, when used alone or concurrently with a
safety guard.
Use of the machine that complies with the information provided in the Instruction
Manual.
Use of the machine that does not comply with the information provided in the
Instruction Manual, but which may be derived from easily predictable behavior.
The process of transferring information and methods to allow those exposed to learn
the correct and safe way to perform the operations assigned to them.
4 GENERAL SAFETY INFORMATION
Do not start the machine without first having read the Instruction Manual and been trained by qualified
personnel.
The user must always comply with local health and safety norms that apply in the country in which the
machine is installed.
Warning and prohibited action decals on the machine
The following warning and prohibited action decals are located on the machine and/or accessories.
Caution, moving parts, do not remove the safety devices.
To Next Page
Loading...