6
Copying all or part of this manual in any way or form is strictly prohibited without written permission from its author © 2015
website: www.fromm-pack.com
Caution, presence of components that may crush or cut.
Caution, hot surfaces.
Do not perform any operations before disconnecting machine voltage.
SAFETY INSTRUCTIONS
CAUTION!
The following conditions must always be met, unless otherwise indicated elsewhere in this manual.
• This machine was delivered by FROMM AIRPAD AG and may be used to create air pillows for packaging, as
indicated in the machine description and the technical data.
Use of the machine other than for its described purpose may represent a hazard, causing damage to the machine and
putting the safety of the operator or other people in the vicinity of the machine at risk.
• Carefully read this manual before using the machine.
• The machine was not built using components that pose particular disposal issues.
• In any event, these components must be disposed of in strict compliance with corresponding laws that are applicable
in the country in which the machine is used, and only by qualified personnel able to assess any potential risks.
• Only personnel trained for this purpose may operate the machine.
• Use the emergency shutdown to stop the machine immediately.
• Only qualified electricians may perform work on the machine’s electrical system.
• When the machine is installed, always make sure that the safety system controls are correctly installed and operate
efficiently. If there are any malfunctions, immediately interrupt the production cycle and ask authorized Technical
Assistance to intervene.
• Perform adjustment and maintenance operations periodically and in compliance with requested requirements, as
indicated in the MAINTENANCE section.
• Safety devices must not be tampered with and/or deactivated.
• The manufacturer supplies the machine ready-to-use, to meet the electrical standards that apply in the country of
use.
• The manufacturer will provide training for machine operators. Otherwise, training must be provided by the installation
company.
• The machines are designed and built to comply with all applicable safety standards.
To Next Page
Loading...