8
7INSTALLATION
Tool must be connected to the line using the original plug / cord only. Supply voltage and frequency must be
identical with the indications on the label.
For the tools with item-No. 43.11.. / 43.18.. / 43.94.. / 43.95.. / 43.96..a helix cable with plug (item- No.
N5. 2122) can be ordered.
Attention! The connecting cable may only be replaced by the manufacturer or by an
authorized specialist.
7.1 Suspension bracket
The tool can be equipped with a suspension bracket
(item-no. P30.1407) and suspended on a balancer.
• Remove screw and nut from bracket. Slip bracket
on bolt; be sure that holes in bracket adapter and
in pin are aligned.
• Secure bracket with screw and nut.
Suspension of tool
For Parts & Service 1-877-862-6699
To Next Page
Loading...
