No. Function
(10) Wire feed speed LED
lights up when the wire feed speed parameter is selected
(11) Overtemperature indicator
lights up if the power source overheats (e.g. because the duty cycle has been
exceeded). For more information on this, see the "Troubleshooting" section.
(12) HOLD indicator
every time a welding operation finishes, the actual values for welding current
and welding voltage are stored, and the HOLD indicator lights up.
(13) Arc length correction LED
lights up when the arc length correction parameter is selected
(14) Droplet detachment correction/arc force dynamic correction/arc force
dynamic LED
lights up when the droplet detachment correction/arc force dynamic
correction/arc force dynamic parameter is selected
(15) Welding voltage LED
lights up when the welding voltage parameter is selected
(16) Welding speed LED
lights up when the welding speed parameter is selected
(17) Right digital display
(18) Job no. LED
lights up when the job number parameter is selected
(19) F3 indicator LED
lights up when the F3 indicator parameter is selected
40
Toowoomba Welding Supplies : tweld.com.au : Ph +61 7 4659 0044
To Next Page
Loading...
Need help?
General
