12
Electrical Installa-
tions
Protective Mea-
sures against
ESD
Safety Measures
in Normal Opera-
tion
Safety Symbols
Disposal
In this case, the operator or the person using the device should check whether
or not the device is allowed to be connected, where appropriate through dis-
cussion with the power supply company.
Electrical installations must only be carried out according to relevant national
and local standards and regulations.
Danger of damage to electrical components from electrical discharge. Suitable
measures should be taken to protect against ESD when replacing and install-
ing components.
Only operate the device when all protection devices are fully functional. If the
protection devices are not fully functional, there is a risk of
- injury or death to the operator or a third party,
- damage to the device and other material assets belonging to the operator,
- inefficient operation of the device
Any safety devices that are not functioning properly must be repaired by au-
thorized personnel before the device is switched on.
Never bypass or disable protection devices.
Devices with the CE marking satisfy the essential requirements of the low-volt-
age and electromagnetic compatibility directives. Further details can be found
in the appendix or the chapter entitled "Technical data" in your documentation.
Do not dispose of this device with normal domestic waste! To comply with the
European Directive 2002/96/EC on Waste Electrical and Electronic Equip-
ment and its implementation as national law, electrical equipment that has
reached the end of its life must be collected separately and returned to an ap-
proved recycling facility. Any device that you no longer require must be re-
turned to your dealer, or you must locate the approved collection and recycling
facilities in your area. Ignoring this European Directive may have potentially
adverse affects on the environment and your health!
To Next Page
Loading...
Need help?
General