27
g
Choosing a loca-
tion for outdoor
installation
Because of its degree of protection, the inverter is not susceptible to splash water from
any direction.
However the manufacturer recommends, if possible, not to expose the inverter to direct
weathering, in order to prevent water deposits caused by rain or snow.
In order to protect the display, the inverter should not be exposed to direct sunlight. Ide-
ally, the inverter should be installed in a protected location, e.g., near the solar modules
or under a roof overhang.
Do not install the inverter:
- where it can be exposed to ammonia, corrosive gasses, acids or salts (e.g., fertilizer
storage areas, vent openings of livestock stables, chemical plants, tanneries)
To Next Page
Loading...
Need help?
General