18
General
Device concept
Cold wire feeder KD 4000 D-11
The cold wire feeder is designed to be used
with wirespools of max. 300 mm (11.81 in)
diameter. The standard 4-roller drive has
good wirefeeding properties. The cold wire
feeder is also suitable for long hosepacks
and,
due to its compact size, can be used in
many different ways.
The cold wire feeder can be used with the
following power sources:
- TransTig 2200 / 2500 / 3000 Job
- TransTig 4000 / 5000 Job
- MagicWave 2200 / 2500 / 3000 Job
- MagicWave 4000 / 5000 Job
Application area The KD 4000 D can be used for all types of TIG welding and is especially suited to robot
applications and automated tasks. The cold wire feeder is suitable for all standard shielding
gases.
Warning notices
on the device
The cold wire feeder has safety symbols on the rating plate. These safety symbols must
not be removed or painted over. The symbols warn against operating the equipment incor-
rectly, as this may result in serious injury and damage.
Do not use the functions described here until you have fully read and understood
the following documents:
- These Operating Instructions
- All the Operating Instructions for the system components, especially the
safety rules
Welding is dangerous. The following basic requirements must be met:
- welders must be sufficiently qualified
- use appropriate protective equipment
- all persons not involved in the welding process must be kept at a safe dis-
tance
To Next Page
Loading...
