25
EN
Inserting the wirespool
Safety
CAUTION!
Risk of injury from springiness of spooled welding wire.
This can result in serious injury and damage to property.
► When threading in the welding wire, hold the end of it firmly, to prevent any injuries that
might be caused by the wire flicking back.
Inserting the wire-
spool
Insert the wirespool; e.g.: Basket-type spool with basket-type adapter (3)
Switch the power source mains switch to the "Off" position
Open left side panel of the wirefeeder:
Place the wirespool and wirespool holder on the correct side
Latch the locking bolt (1) into opening provided on the spool body
Adjust braking force with clamping screw (2)
Close left side panel of the cold wire feeder again
Always adjust the brake so that the wirespool does not continue unreeling after the end of
welding - but without overtightening the clamping screw, as this might cause motor over-
load.
WARNING!
Danger from incorrect installation
This can result in serious injury and damage to property.
► Do not carry out the steps described here until you have read and completely under-
stood all the Operating Instructions
(1)(2)(3)
1
3
4
6
To Next Page
Loading...
