Fronius PV Point - 1 Introduction

Quick guide PV Point & PV Point Comfort 415
1 Introduction
The PV Point is the basic backup power supply for the Fronius GEN24 & GEN24 Plus series and is
integrated into the device as standard. A socket can be installed on the PV Point, which is supplied in the
event of a grid outage based on the currently available PV generator output (or existing battery).
Switching is automated by the inverter and does not require any additional grid switching components.
The PV Point can be used to supply all important single-phase loads in the household up to 3 kW. The
PV Point does not require the installation of a storage unit - but it can also be installed with a storage
unit as an option.
By installing the PV Point Comfort, the supplied socket or circuit can also be supplied permanently,
i.e. in parallel grid operation, unlike the PV Point. To do this, an additional circuit board must be
installed in the connection area of the inverter. This can also be retrotted at any time at a later date.
The functional diagram of the PV Point & PV Point Comfort is shown in Figure 1:
Figure 1: Schematic of the basic backup power supply (PV Point & PV Point Comfort) of the
Fronius GEN24 & GEN24 Plus series