Fronius Robacta TC 2000 - Magnetic Flux Densities Within the Cleaning Coil for Robacta TC 2000, Robacta TC 2000 US

21
EN
- Automatic refilling of the dipping bowl with "Robacta TC Cool / Robacta TC Cool MD"
parting agent ensures an optimum fill level in the dipping bowl. After draining the "Ro-
bacta TC Cool / Robacta TC Cool MD" parting agent container, the fill level in the dip-
ping bowl drops. The level sensor detects that the level has dropped too low and the
fill level indicator lights up. At the same time, the "Fluid level control" signal is trans-
mitted to the robot control.
- The device cleaning function remains available even if the fill level indicator is il-
luminated.
Magnetic flux
densities within
the cleaning coil
for Robacta TC
2000, Robacta TC
2000 US
Depending on the application, the strength of the magnetic flux density on the individual
areas of the welding torch can be controlled by regulating how deeply the welding torch is
immersed in the cleaning coil.
NOTE! If the robot control deactivates the "Quick Stop" signal during the pro-
gram sequence, the cleaning device program sequence is interrupted imme-
diately. For safety reasons the capacitors are discharged via the cleaning
coil.
NOTE! When using the cleaning device, refer to the program sequence for details
of the welding torch immersion depth.
Cleaning coil
Diagram showing available
magnetic flux density
Immersion depth of
torch neck into clean-
ing coil
0 % 100 %
50 mm
1.97 in.
10 mm
0.39 in.
15 mm
0.59 in.