Fronius Robacta TC 2000 - How the Electrically-Controlled Wire Cutter Works

43
EN
Mechanically controlled wire cutter for conventional
applications (using one wire electrode)
If a torch neck pushes the valve lever (1) to
the side by more than 15° with the gas
nozzle, the wire cutter is activated and the
wire electrode is cut.
How the electri-
cally-controlled
wire cutter works
The electrically-controlled wire cutter opens and closes when there is an active signal from
the robot control.
(1)
NOTE! The wire electrode is cut
while the torch neck is moving.