Fronius Robacta TC 2000 - Troubleshooting, Maintenance, and Disposal

61
EN
Care, maintenance and disposal
Before each start-
up
- Check the fill level in the "Robacta Reamer" parting agent container and the dipping
bowl, top up if necessary
Daily
Weekly - Empty the spatter tray for welding residues
- Take the spill tray out of the dipping bowl and dispose of any accumulated dirt
- Check the consistency of the "Robacta TC Cool / Robacta TC Cool MD" parting agent.
If the "Robacta TC Cool / Robacta TC Cool MD" parting agent is viscous, add fresh
water and stir to mix with the parting agent
- Check the level sensor in the dipping bowl for dirt and clean if necessary
- Clean the cleaning opening on the inside
- Check the "Robacta Reamer" and "Robacta TC Cool / Robacta TC Cool MD" parting
agent containers for soiling and clean if necessary
- Blow compressed air through the suction filter in the "Robacta Reamer" parting agent
container from the inside outwards using the suction hose (see "Connecting the clean-
ing device to the "Robacta Reamer" parting agent container")
- Check the condition of the brush seal above the cleaning opening. Replace the brush
seal if worn (not applicable for twin devices)
Every 3 months
- Drain all the parting agent from the dipping bowl
- Take the spill tray out of the dipping bowl and dispose of any accumulated dirt
- Clean the dipping bowl and spill tray
- Fill the dipping bowl with new parting agent
Every 6 months
- Open the device and blow clean using dry reduced compressed air
Every 12 months - Arrange for a safety inspection to be carried out on the device by a Fronius service
engineer
Disposal Dispose of in accordance with the applicable national and local regulations.
NOTE! The "Robacta TC Cool / Robacta TC Cool MD" and "Robacta Reamer"
parting agents differ in their composition. Use the appropriate medium depending
on the application concerned.
NOTE! Clean the device exterior of any parting agent or dirt, especially on top.
Only use solvent-free cleaning products on the device.
NOTE! Take care never to damage the level sensor when performing mainte-
nance work.
NOTE! Do not bring the air nozzle too close to electronic parts.