12
The Setup wizard start page is displayed.
If you run the technician wizard, always remember to make a note of the assigned service
password. This service password is required to enter settings in the "System overview" and
"DNO Editor" menus as well as for advanced battery settings.
If the technician wizard is not run, no specifications regarding power reduction are set and
hybrid mode is not possible (charging and discharging of the battery)
Run the technician wizard and follow the instructions
Installation using the Solar.web app Installation using a web browser
Download the Fronius Solar.web App
Run the Fronius Solar.web app
Connect the end device to the WLAN
access point
SSID = FRONIUS_239.xxxxx (4-8
digits)
- Search for a network with the
name "FRONIUS_239.xxxxx"
- Establish a connection to this
network
- Enter the password 12345678
(Alternatively, connect the end device
and inverter using an Ethernet cable.)
Enter the following in the browser:
http://datamanager
or
192.168.250.181 (IP address for
WLAN connection)
or
169.254.0.180 (IP address for LAN
connection)
2
3
2
3
4
To Next Page
Loading...
