Fronius Symo Hybrid - Installing and Configuring System Monitoring; System Monitoring Setup Safety; Initial System Monitoring Setup

11
EN
Installing and configuring Fronius system monitor-
ing
Safety
WARNING!
Danger from incorrect operation
This can result in severe personal injury and damage to property.
► Do not use the functions described here until you have fully read and understood the
Operating Instructions of every system component:
► Do not use the functions described here until you have read and understood all the
safety rules.
IMPORTANT! Knowledge of networking systems is required in order to install Fronius sys-
tem monitoring.
Starting for the
first time
IMPORTANT! Starting up the Fronius system monitoring function for the first time is made
considerably easier with the Fronius Solar.web app. The Fronius Solar.web app is availa-
ble in the respective app stores.
IMPORTANT! In order to establish a connection to Fronius system monitoring, the end de-
vice in question (e.g. laptop, tablet, etc.) must be set up as follows:
- "Obtain IP address automatically (DHCP)" must be activated
Switch the device to Service mode
- Activate the WLAN Access Point via the Setup menu on the inverter
The inverter establishes the WLAN access point. The WLAN access point remains open
for 1 hour.
Or visit
https://wizard.solarweb.com
1
Relay
Standby
WiFi Access Point
Relay
Clock
Display Setting