LOV
™
Technical Reference
33
8. “Engage Dispose Switch” is displayed. Switch the RTI switch to dispose.
9. Press the “9” to start disposal. “Pan to Waste” displayed.
10. “Pan Empty” is displayed after 60 seconds.
11. Press “9” if oil in fi lter pan is empty. Select “8” if pan still has oil in it, and pump will run for another 60 seconds.
12. “Disengage Dispose Switch” is displayed. Switch off the RTI dispose switch.
13. “Fill Pot From Bulk” is displayed.
14. Press “8” if you wish to leave pot empty and exit program.
Fill Pot From Bulk
1. Hold down “fi lter” button until computer beeps twice.
2. Scroll down to “Fill Pot From Bulk.”
3. Press and hold “9” if you wish to fi ll pot.
4. Release “9” once pot is at desired level.
5. Press “8” to Exit program.
Fill Jug From Bulk
1. When “Yellow” LED indicator light is on, the pot top-off jug is empty.
2. To refi ll jug press ADD button on the RTI box located on back side of door that accesses jug.
3. Hold down button until oil is to desired level in jug.
4. Press the JIB reset button above the jug to turn the yellow LED off and reengage the ATO system.
Jug and Vat Won’t Fill
1. Enter FLTR MENU by pressing and holding the FLTR BUTTON.
2. Scroll to FILL POT FROM BULK. Press 1.
3. Computer displays FILL POT FROM BULK/YES NO. Press 1.
4. When the actuator opens, press 1 briefl y again. Press 2.
5. Try to fi ll pot or JIB to see if issue resolved. If not, contact RTI.
To Next Page
Loading...
