700-Bubbler-Man Rev 12 13 Feb 2020
Page 28/51
4.6 SAVE CONFIGURATION
Once all tabs have been completed, select the OK checkmark on any tab. The SDI Sensor Mapping
screen should display and indicate the sensor is mapped. View the Bubbler Sensor Screen and
confirm configuration (see section 4.7).
4.7 BUBBLER SENSOR SCREEN
From the home screen select the Sensors icon and then the Bubbler icon. Note that the name on
the icon will be the same as the Sensor Name input on the Sensor tab. This example retains the
default name.
All defined data points defined in the Bubbler Sensor Setup tabs will be displayed with the latest
measured values. Use the setup cog to display and edit the Bubbler Sensor Setup screen.
To Next Page
Loading...
