14 Rev 007, 04/12
© SP Scientific 2012
Prime the Fluid Loop
At this point your unit should be hooked up to the proper electrical service and all
plumbing necessary for operation should be in place and sealed.
Make sure the drains are CLOSED. 1.
Switch ON the rocker switch on the front panel of the machine. 2.
The amber POWER light should illuminate. 3.
Remove the reservoir lid on the top of the unit. 4.
CORROSIVE CHEMICAL!. WEAR SUITABLE GLOVES, SAFETY GLASSES, AND PROTECTIVE
CLOTHING.
Add process fluid to reservoir until it is 1" (2.5cm) from the top 5.
Replace lid 6.
Press the I/O button. 7.
When the reservoir drops to 1/3 full, press the I/O button to stop the pump. 8.
Remove the reservoir lid. 9.
Add fluid to reservoir until it is again 1" (2.5cm) from the top. 10.
Replace the reservoir lid. 11.
Restart the pump by pressing the I/O button again.
12.
Continue this process until the entire fluid loop is primed and the reservoir 13.
level remains 1" (2.5cm) from the top.
Your unit is now fully installed and ready to operate.
To Next Page
Loading...
