Rev 007, 04/12 29
© SP Scientific 2012
Maintenance
WARNING! INJURY OR EVEN DEATH MAY RESULT IF A RECOMMENDATION MARKED WITH
THIS SYMBOL IS NOT HEEDED.
ELECTRIC SHOCK DANGER! USE APPROPRIATE CAUTION TO AVOID INJURY OR DEATH.
BURN DANGER! POTENTIALLY HOT SURFACE. USE APPROPRIATE CAUTION.
ALWAYS REMOVE POWER FROM THE UNIT BEFORE PERFORMING MAINTENANCE
PROCEDURES.
Note: Always notify the SP Scientific Service Department before performing repairs to a unit
that is under warranty. Failure to notify SP Scientific Service will void the factory warranty.
Lockout/Tagout Procedure
To prevent accidental or unauthorized starting of this unit during maintenance,
disconnect the power cord and install an appropriate lockout device on the end of the
power cord.
This unit is provided with a line cord with a standard NEMA 5-15P or 6-15P. Lockout
of the equipment can be accomplished at the end of the equipment’s power cord.
To Next Page
Loading...
