SeaSTAR 3610 USER MANUAL
• Avoid routing cables along-side power generator cabling and other high
electrical noise sources. This can cause interference.
• Do not kink or force cables into sharp bends that may damage the cables and
cause system failure.
• After installation, ensure that excess cable is looped and clamped or tied safely
away from any control cables, fuel lines, hydraulic lines or moving parts. When
stowing over-length cables, form loops not less than 150 mm minimum cable
bend radius.
• Cable routing must avoid high temperature exposure (e.g. exhaust manifold).
Issue 2.0 02/10
24
To Next Page
Loading...
