10-8
10.4.2 Compliance with the harmonic component regulation
Table 10.3 Compliance with Harmonic Component Regulation
Power supply
voltage
Inverter type w/o DC reactor w/ DC reactor
Applicable
DC reactor type
FRNF12E1ع-2U * * DCR2-0.2
FRNF25E1ع-2U * * DCR2-0.2
FRNF50E1ع-2U * * DCR2-0.4
Three-phase
230 V
FRN001E1ع-2U * * DCR2-0.75
FRNF50E1ع-4U — DCR4-0.4
Three-phase
460 V
FRN001E1ع-4U — DCR4-0.75
FRNF12E1ع-7U — DCR2-0.2
FRNF25E1ع-7U — DCR2-0.4
FRNF50E1ع-7U — DCR2-0.75
Single-phase
230 V
FRN001E1ع-7U — — DCR2-1.5
* When supplying three-phase 230 VAC power stepped down from a three-phase 460 VAC power line
using a transformer, the level of harmonic flow from the 460 VAC line will be regulated.
Note 1)
A box (
) in the above table replaces S or E depending on the enclosure.
Note 2)
Inverter types marked with in the table above are compliant with the EN61000-3-2 (+A14), so they may
be connected to public low-voltage power supply unconditionally.
Conditions apply when connecting models marked with “—“. If you want to connect them to public low-
voltage power supply, you need to obtain permission from the local electric power supplier. In general,
you will need to provide the supplier with the harmonics current data of the inverter. To obtain the data,
consult your Fuji Electric representative.
10.5 Compliance with the Low Voltage Directive in the EU
10.5.1 General
General-purpose inverters are regulated by the Low Voltage Directive in the EU. Fuji Electric states
that all our inverters with CE or TÜV mark are compliant with the Low Voltage Directive.
10.5.2 Points for consideration when using the FRENIC-Multi series in a system to be
certified by the Low Voltage Directive in the EU
If you want to use the FRENIC-Multi series of inverters in systems/equipment in the EU, refer to
the guidelines on page vi.
To Next Page
Loading...
