3-15
(5) Change the function code data using the and keys. (In this example, press the key
two times to change data
to
.)
(6) Press the
key to establish the function code data.
The
UCWG
appears and the data will be saved in the memory inside the inverter. The display will
return to the function code list, then move to the next function code. (In this example,
H
.)
Pressing the
key instead of the key cancels the change made to the data. The data
reverts to the previous value, the display returns to the function code list, and the original
function code reappears.
(7) Press the
key to return to the menu from the function code list.
Cursor movement
You can move the cursor when changing function code data by holding down the
key
for 1 second or longer in the same way as with the frequency settings. This action is called
"Cursor movement."
Figure 3.3 Example of Function Code Data Changing Procedure
3.4.2 Setting up function codes -- Menu #1 "Data Setting" --
Menu #1 "Data Setting" in Programming mode allows you to set up function codes for making the
inverter functions match your needs.
To set function codes in this menu, it is necessary to set function code E52 to "0" (Function code data
editing mode) or "2" (Full-menu mode).
Basic key operation
For details of the basic key operation, refer to Menu #0 "Quick Setup" in Section 3.4.1.
To Next Page
Loading...
