2-26
(2) Parts needed for connection
To mount/install a keypad on a place other than an inverter, parts listed below are needed.
Parts name Model Remarks
Extension cable (Note) CB-5S, CB-3S and CB-1S
3 cables available in length of 16ft (5m), 9.8ft
(3m), and 3.3ft (1m).
Fixing screw M3 u 16
Accessories
Keypad rear cover
Accessories
(Note) When using an off-the-shelf LAN cable, use a 10BASE-T/100BASE-TX straight type cable
compliant to US ANSI TIA/EIA-568A Category 5. (Less than 66ft(20m))
Recommended LAN cable
Manufacturer: SANWA Supply Co., LTD.
Model: KB-10T5-01K (3.3ft(1m))
KB-STP-01K (3.3ft(1m)) (Shielded LAN cable compliant to EMC Directive)
2.4.2 Mounting/installing steps
Mounting a keypad on the panel wall
Pull the keypad toward you while holding down the hooks on the keypad.
Figure 2.25 Removing a Keypad
Fix the keypad rear cover to the keypad.
Figure 2.26 Fixing the Keypad Rear Cover for Remote Keypad Operation
To Next Page
Loading...
