Fuji Electric FRENIC-Multi - Running Mode; Monitoring the Running Status

3-4
3.3 Running Mode
When the inverter is turned ON, it automatically enters Running mode in which you can:
(1) Monitor the running status (e.g., output frequency and output current),
(2) Configure the reference frequency and other settings,
(3) Run/stop the motor, and
(4) Jog (inch) the motor.
3.3.1 Monitoring the running status
In Running mode, the eleven items listed below can be monitored. Immediately after the inverter is
turned ON, the monitor item specified by function code E43 is displayed. Press the
key to switch
between monitor items. For details of switching the monitor item by using the
key, refer to
"Monitor of running status" in Running mode in Figure 3.1.
Table 3.3 Monitoring Items
Monitor items
Display
sample on
the LED
monitor *
1
LED indicator
: ON, : OFF
Unit Meaning of displayed value
Function
code data
for E43
Speed monitor
Function code E48 specifies what to be displayed on the LED monitor
and LED indicators.
0
Output frequency
(before slip
compensation)
 Hz A kW Hz Frequency actually being output (E48 = 0)
Output frequency
(after slip
compensation)
 Hz A kW Hz Frequency actually being output (E48 = 1)
Reference
frequency
 Hz A kW Hz Reference frequency being set (E48 = 2)
Motor speed
 Hz A kW r/min
P01
120
×(Hz)frequencyOutput
For motor 2, read P01 as A15.
(E48 = 3)
Load shaft speed
 Hz A kW r/min Output frequency (Hz) u E50 (E48 = 4)
Line speed
 Hz A kW m/min Output frequency (Hz) u E50 (E48 = 5)
Constant feeding
rate time
 Hz A kW min
E39×(Hz)frequencyOutput
E50
(E48 = 6)
Output current  Hz A kW A
Current output from the inverter
in RMS
3
Output voltage *
2
W Hz A kW V
Voltage output from the inverter
in RMS
4
Calculated torque
 Hz A kW %
Motor output torque in %
(Calculated value)
8
Input power  Hz A kW kW Input power to the inverter 9