Fuji Electric FRENIC-Multi - Page 55

3-5
Table 3.3 Monitoring Items (Continued)
Monitor items
Display
sample on
the LED
monitor *
1

LED indicator
: ON, : OFF
Unit
Meaning of displayed value
Function
code E43
PID command
*
3
, *
4
 Hz A kW 㧙 10
PID feedback
amount *
3
, *
5
 Hz A kW 㧙
PID command/feedback amount
transformed to that of virtual
physical value of the object to be
controlled (e.g. temperature)
Refer to function codes E40 and
E41 for details.
12
Timer
(Timer operation) *
3
 Hz A kW min
Remaining time of timer opera-
tion
13
PID output *
3
, *
4
   Hz A kW %
PID output in % as the
maximum frequency (F03)
being at 100%
For motor 2, read F03 as A01.
14
Load factor *
6
 Hz A kW %
Load factor of the motor in % as
the rated output being at 100%
15
Motor output *
7
 Hz A kW kW Motor output in kW 16
*
1
A value exceeding 9999 cannot be displayed on the 4-digit LED monitor screen, so " "
appear instead.
*
2
When the LED monitor displays an output voltage, the 7-segment letter
W  in the lowest digit
stands for the unit of the voltage "V."
*
3
These PID related items appear only when the inverter PID-controls the motor according to a
PID command specified by function code J01 (= 1, 2 or 3).
The Timer item appears only when the timer operation is enabled with function code C21.
When the PID control or timer operation is disabled, "----" appear.
*
4
When the LED monitor displays a PID command or its output amount, the dot (decimal point)
attached to the lowest digit of the 7-segment letter blinks.
*
5
When the LED monitor displays a PID feedback amount, the dot (decimal point) attached to the
lowest digit of the 7-segment letter lights.
*
6
When the LED monitor displays a load factor, the 7-segment letter
 in the lowest digit stands for
"%."
*
7
When the LED monitor displays the motor output, the unit LED indicator "kW" blinks.