3-3
Figure 3.1 shows the status transition of the inverter between these three operation modes.
(*1) The speed monitor allows you to select the desired one from the seven speed monitor items by using
function code E48.
(*2) Applicable only when PID control is active (J01 = 1, 2 or 3).
(*3) The Timer screen appears only when the timer operation is enabled with function code C21.
(*4) Applicable only when the full-menu mode is selected (E52 = 2).
(*5) Pressing
key can reset an alarm only when the latest alarm is displayed on the LED monitor.
Figure 3.1 Transition between Basic Screens in Individual Operation Mode
To Next Page
Loading...
