2-27
Make a cut-out on the panel wall. For details, refer to Chapter 8, Section 8.4.2 "Standard
keypad."
To mount the keypad on the panel, fix it firmly using a pair of M3 screws put through the
taps shown below. (Figure 2.27.)
(Tightening torque: 6.2 Ib-in (0.7 Nm))
Figure 2.27 Mounting a Keypad on the Panel Wall
Connect an extension cable (CB-5S, CB-3S or CB-1S) or off-the-shelf straight LAN cable
to RJ-45 connectors (Modular jacks) on the keypad and inverter (standard RS-485 port.)
(Refer to Figure 2.28)
Figure 2.28 Connecting a Keypad and an Inverter’s Standard RS-485 port
Installing a keypad at a remote site (e.g. for operation on hand)
Follow the step
in Mounting a keypad on the panel wall.
To Next Page
Loading...
