3-14
Figure 3.2 shows the menu transition in Menu #0 "Quick Setup."
Figure 3.2 Menu Transition in Menu #0 "Quick Setup"
Basic key operation
This section gives a description of the basic key operation, following the example of the function
code data changing procedure shown in Figure 3.3.
This example shows you how to change function code F01 data from the factory default "
/
keys on keypad (F01 = 0)" to "Current input to terminal [C1] (C1 function) (4 to 20 mA DC) (F01 = 2)."
(1) Turn the inverter ON. It automatically enters Running mode. In that mode, press the
key to
switch to Programming mode. The function selection menu appears. (In this example,
HP
is
displayed.)
(2) If anything other than
HP
is displayed, use the and keys to display
HP
.
(3) Press the
key to proceed to a list of function codes.
(4) Use the
and keys to display the desired function code (
H
in this example), then
press the
key.
The data of this function code appears. (In this example, data
of
H
appears.)
To Next Page
Loading...
