Displaying the status of inverter at the time of alarm
When the alarm code is displayed, you may check various running status information (output
frequency and output current, etc.) by pressing the
key. The item number and data for each
running information will be displayed alternately.
Further, you can view various pieces of information on the running status of the inverter using the
/ key. The information displayed is the same as for Menu #6 "Alarm Information" in Programming
mode. Refer to Table 3.21 in Section 3.4.7, "Reading alarm information."
Pressing the
key while the running status information is displayed returns the display to the alarm
codes.
When the running status information is displayed after removal of the alarm cause, pressing
the
key twice returns to the alarm code display and releases the inverter from the alarm
state. This means that the motor starts running if a run command has been received by this
time.
Switching to Programming mode
You can also switch to Programming mode by pressing
+ keys simultaneously with the alarm
displayed, and modify the function code data.
Figure 3.7 summarizes the possible transitions between different menu items.
Figure 3.7 Menu Transition in Alarm Mode
To Next Page
Loading...
