Fuji Electric PXR3 - Page 15

– 15 –
After the parameter has been changed, if unoperated state continues for 30 seconds without pressing the
key, setting change becomes invalid.
Caution
If it is left in this state for 30 seconds,
the change becomes invalid, and
it returns to Operation/Standby mode.
Caution
SEL
SEL
SEL
SEL
SEL
SEL
SEL
1
1
3
2
Press the
once.
Press the for 2 sec.
Parameter selection
Parameter setting procedure
Select a parameter you want to set by pressing the or key.
3
To shift to Operation/Standby mode, press the key for 2 sec.
4
If unoperated state continues for 30 seconds, it returns to Operation/Standby mode.
2-1
Press the key to display the parameter set value.
2-2
Pressing the or key, change the parameter set value.
2-3
After the parameter has been changed, press the key for registration.
Parameter settings
Shift to operating condition
Parameter search.
SEL
Press the
once.
Parameter set value change.
1
Registers parameter set value,
and returns to the parameter
selection mode .
By repeating the same procedure, the
parameters can be displayed according to
the parameter list shown in “5, Setting
methods of temperature and parameters”.
Operation mode
(SV display)
Press the . Press the .
Increases parameter
set value
Decreases parameter
set value
SV
C1
SEL
C2
AL1
AL2
SV
C1
SEL
C2
AL1
AL2
When the set value is changed,
the numeric value flickers.
SV
C1
SEL
C2
AL1
AL2
SV
C1
SEL
C2
AL1
AL2
SV
C1
SEL
C2
AL1
AL2
Parameter setting mode
Switching by
the key
SEL