–
14
–
4 Display and operation
Standby mode
SEL
SV
C2
C1
SEL
AL2
AL1
SV
C2
C1
SEL
AL2
AL1
SEL
SV
C2
C1
SEL
AL2
AL1
SV
C2
C1
SEL
AL2
AL1
· To perform standby operation, set "STby" as ON in the
1st block parameter.
Caution
Caution
· Standby mode:
(Output) Control outputs (1 and 2) and alarm outputs (all) are not provided. However,
depending on setting of "P-n1", control action, control outputs are provided at the abnormal input.
No alarm output is provided at standby mode, even in (Fault-condition).
(Control) Control is not performed.
(Display) While PV being displayed ; SV indication lamp flickers.
While SV being displayed ; SV display value flickers.
(Setting) SV and parameter settings are able to perform.
Be careful since the equipment does not provide output of the alarm of the main
unit abnormality during the standby operation.
The SV display does not flicker while the 1st, 2nd and 3rd block parameters are displayed.
Press the
once
SV indication lamp is lit
The set value (SV) flickers
Showing the process value (PV) Showing the set value (SV)
SV indication lamp is lit
Showing the process value (PV) Showing the set value (SV)
1
Change of set value (SV)
2
Shift to the 1st, 2nd and 3rd block parameter
To shift to the other blocks, press the key.
After the data setting, the data are registered automatically in 3 seconds.
Depending on the pressing time of key, you can select the block to shift.
The set value (SV) can be changed.
SEL
SEL
SEL
pressing time Shifting block
About 1 sec pressing 1st block
About 3 sec pressing 2nd block
About 5 sec pressing 3rd block
Caution
once
Press the
once
Operation mode
SV indication lamp flickers
Switching by
1st block
STby settings
To Next Page
Loading...
