Layout Adjustment
101
Copy
3
Ending Page
z
[Left Page] / [Right Page]
You can select these options when [Left Page then Right] or [Right Page then Left]
is selected.
z
[Top Page] / [Bottom Page]
You can select these options when [Top Page then Bottom] is selected.
Original Size (Specifying the Scan Size for the Document)
This feature allows you to specify the scan size for a document.
Use this feature when a document is a non-standard size, or when you want to copy a
document at a size different from the original size. You can also add margins, or delete
unnecessary margins using this feature.
1 Select [Original Size].
2 Select the size of the document.
If you select a non-standard size, specify
values for the X and Y directions.
Auto Detect
Detects the document size automatically. The following table shows the document
sizes that can be detected automatically.
Note • If the document size cannot be detected automatically, a screen to enter the document size
appears.
The document sizes that can be automatically detected depend on the [Paper Size Settings] made in
System Administration mode. For more information, refer to "5 Tools" > "Common Service Settings" >
"Other Settings" > "Paper Size Settings" in the Administrator Guide.
Standard Size
Select a document size from preset options.
You can change the sizes displayed on the screen. For information on the settings, refer to "5 Tools" >
"Copy Service Settings" > "Original Size Defaults" in the Administrator Guide.
Document feeder Document glass
Auto-detectable
Document Sizes
B5, B5 , B4, A5, A5 , A4, A4 ,
A3, 8.5 x 11", 8.5 x 11" ,
11 x 17", 16K , 8K
B6, B5, B5 , B4, A6, A5, A5 ,
A4, A4 , A3, 8.5 x 11" ,
11 x 17", 16K, 16K , 8K
To Next Page
Loading...
