Fuji Xerox ApeosPort-IV 3070

Fax/Internet Fax
197
Fax
4
Original Type (Selecting the Document Type)
You can select the type of the original document, such as text and photo documents.
1 Select the document type.
Text
Select this option when transmitting a document that contains only text.
Photo & Text
Select this option when transmitting a document that contains both text and photos.
The machine automatically distinguishes the areas with text and those with photos and
sets the appropriate image quality for each area of the document.
Photo
Select this option when transmitting a document that contains only photos.
Note • If reduced in size, the scan documents may have stripes in the areas with photos.
Resolution (Specifying the Scanning Resolution)
You can set the resolution for the documents to be scanned.
Note • The machine scans a document at the specified resolution, but if the recipient's machine
does not support the resolution, the machine automatically changes the resolution to one
supported by the recipient's machine and there is a corresponding loss in quality.
• The higher the resolution, the lower the transmission speed. Usually, we recommend that
you select [Superfine (400 dpi)] or lower.
• Only [Fine (200 dpi)] is available for the Server Fax service.
You can specify the resolution for each address number. For information on how to register address
numbers, refer to "5 Tools" > "Setup" > "Add Address Book Entry" in the Administrator Guide.
1 Select the resolution.
Standard (200 x 100dpi)
Select this option when transmitting standard documents.
(Approx. 200 x 100 pels/25.4 mm)
Fine (200 dpi)
Select this option when transmitting documents with small text or detailed images.
(Approx. 200 x 200 pels/25.4 mm)