1 Before Using the Machine
26
Before Using the Machine
1
5) Press the <TEST> button lightly with a
sharp edge such as a pen tip. If the
<RESET> button pops up, it means that
the ground fault interrupter circuit is
working properly. If not, the circuit is not
working properly.
6) Press the <RESET> button back to the
depressed position.
If the circuit does not work properly,
contact your local Fuji Xerox representative.
Do not attempt to remove a paper deeply jammed inside the product,
particularly a paper wrapped around the fusing unit or the heat roller.
Otherwise, it may cause injuries or burns. Switch off the product immediately
and contact your local Fuji Xerox representative.
Never touch the paper output area of the finisher during operation. It may
cause injuries.
Be careful in removing jammed staples.
Be careful not to get injured by waste staples when detaching a staple dust
box.
Waste staples may come out with output paper. Be careful not to get injured
by the staples.
Never touch safety interlocks. When a front cover is open, safety interlocks
become activated to stop the machinery. Do not apply pressure on safety
interlocks with a coin or screwdriver. Otherwise, the machinery may become
activated and cause injuries.
Do not staple punched holes of paper. Sharp points of a staple may cause
injuries.
Do not apply excessive force to hold thick document on the document glass. It
may break the glass and cause injuries.
To move this product to another location, contact your local Fuji Xerox
representative.
Ventilate well during extended operation or mass copying. It may affect the
office air environment due to odor such as ozone in a poorly ventilated room.
Provide proper ventilation to ensure the comfortable and safe environment.
<TEST> button
<RESET>
button
<RESET> button
To Next Page
Loading...
Need help?
General
