Layout Adjustment
113
Copy
3
Edge Erase (Erasing Edges and Margin Shadows of the Document)
When you copy a document with the document cover open or when you copy a book,
the edges and center margin of the document may be printed as black shadows. The
Edge Erase feature allows you to erase such shadows.
Note • For 2-sided originals, the same edge erase amounts are set for the front and back sides.
• If you set [Reduce/Enlarge], the edge erase amounts will be reduced or enlarged in
proportion to the ratio you specified.
• The binding shift specified in [Booklet Creation] will not affect the edge erase amounts.
• If original is placed on the document glass and [1
J2 Sided] is selected when using 2 Sided
Copying feature, symmetrical edge erase amounts on both sides are not applied to output
even if [Individual Edges] is specified and [Mirror Side 1] is selected as [2 Sided Original -
Side 2] option. To apply symmetrical edge erase amounts on both sides, select [2
J2 Sided]
for 2 Sided Copying operation.
Even when the edge erase amount is set to 0 mm, full page copying cannot be made. For information on
the areas that can actually be printed, refer to "16 Appendix" > "Printable Area" in the Administrator
Guide.
1 Select [Edge Erase].
2 Select any option.
îš„Normal
The edge width to erase is set to 2 mm for the top and bottom, and left and right edges.
îš„All Edges
Erases the shadows of the four edges of a document, as well as the shadow in the
center of the document if it is a bound document or a booklet. You can specify values
for [All Edges] and [Center] individually.
îš„Individual Edges
Erases the shadows of the top, bottom, left, and right edges of a document, as well as
the shadow in the center of the document if it is a bound document or a booklet. You
can specify values for [Top], [Bottom], [Left], [Right], and [Center] individually.
îš„Parallel Edges
Erases the shadows of the top and bottom edges, and left and right edges of a
document, as well as the shadow in the center of the document if it is a bound
document or a booklet. You can specify values for [Top & Bottom], [Left & Right], and
[Center] individually.
To Next Page
Loading...
Need help?
General
