Simple Fax
193
Fax
4
1 Press the <Speed Dial> button, and enter a
4-digit address number.
Note • If you have entered an incorrect value,
press the <C (Clear)> button and enter
the correct value.
2 Press the <Start> button.
3 Confirm the destination displayed on the touch screen, and then select [Yes].
Specifying a Destination Using a One Touch Button
You can use the one touch buttons to specify recipients.One touch buttons correspond
to the address numbers from 0001 to 0070, or 0001 to 0060. For example, when the
number you want to dial is registered to the address number 0001, press one touch
button <1>.
For information on how to register address numbers, refer to "5 Tools" > "Setup" > "Add Address Book
Entry" in the Administrator Guide.
Note • There are two ways in which address numbers and stored programs are assigned to the one
touch buttons. Select either of the following. By default, [Type 1] is selected.
• [Type 1]
The buttons 1 to 70 are used for address numbers and they correspond to the registered
address numbers 0001 to 0070, while the buttons 71 and 72 are used for stored programs
and they correspond to the registered stored programs 1 and 2.
• [Type 2]
The buttons 1 to 60 are used for address numbers and they correspond to the registered
address numbers 0001 to 0060, while the buttons 61 to 72 are used for stored programs
and they correspond to the registered stored programs 1 to 12.
<Speed Dial> button
<Start> button
To Next Page
Loading...
Need help?
General
