3 Copy
88
Copy
3
z
Fit Image to Paper Size X - Y%
Automatically determines the reduction/enlargement ratios for the width and length
so that the document image fits in the paper, and then slightly reduces the ratios so
that the complete image is copied onto the paper.
z
Width: XX% Length: XX%
Allows you to specify the preset reduction/enlargement ratios.
When [Calculator %] is Selected
You can specify values for the length and width individually.
If you specify both the original document size and the desired copy size, the copy ratios
for the length and width are calculated automatically in the range from 25 to 400%
according to the values that you entered.
Important • Selecting [Calculator %] allows you to set copy ratios. The values entered in [Original Size]
and [Copy Size] are used to calculate ratios, and do not reflect a scan size for the document
or the paper size. Be sure to specify a scan size for the document. Also, select a paper tray
if necessary.
For information on how to specify a scan size for the document, refer to "Original Size (Specifying the
Scan Size for the Document)" (P.111). For information on how to select a paper tray, refer to "Paper
Supply (Selecting the Paper for Copying)" (P.89).
1 Enter the width of the original document in
[Original Size] of [Width X%] using the
numeric keypad.
2 Enter the width of the output copy in [Copy Size] of [Width X%] using the numeric
keypad.
3 In the same way, enter the length for [Original Size] and [Copy Size] of [Length Y%].
îš„Width X% / Length Y%
Displays the ratios that are automatically calculated using the values set in [Original
Size] and [Copy Size].
îš„Original Size
Allows you to enter the width and length of the original document, in the range from 1
to 999 mm in 1 mm increments.
îš„Copy Size
Allows you to enter the width and length of output copies, in the range from 1 to 999
mm in 1 mm increments.
To Next Page
Loading...
Need help?
General
