Copy Mode Settings
293
System Settings
11
4 Select the feature to be displayed,
and select [Save].
Note • Select [ ] to return to the
previous screen or [ ] to
move to the next screen.
5 Repeat Steps 3 and 4 as required.
Number of Display Buttons
Set how many buttons, 4 or 5 buttons, to display for each of the [Reduce/Enlarge], [Paper
Tray], [2 Sided Copying] and [Copy Output] features on the [Copy] tab.
If you select [4 Buttons], the images of the selected options are displayed on the [Copy] tab.
Paper Supply - Buttons 2 to 4
For the 5 feature buttons appearing in [Paper Supply] on the [Copy] screen, you can set the
second to fourth paper trays from the top. Select from the Trays 1 to 4, and Tray 5 (Bypass).
Reduce/Enlarge - Buttons 3 and 4
For the 5 feature buttons appearing in [Reduce/Enlarge] in the [Copy] screen, you can set the
ratio for the third and forth rows from the top.
You can select the ratio from the registered R/E Preset buttons.
Copy Defaults
This sets the default settings of copy feature settings. When the power is turned on or
the machine returns from a Power Save mode, or when the <Clear All> button is
pressed, the system returns to the defaults set here. By setting features you often use
as defaults, you can avoid extra operations required in use.
Paper Supply
Set the default value for [Paper Supply] in the [Copy] screen.
When the default value of [Reduce/Enlarge] is set to [Auto %], [Auto Paper] cannot be
selected for [Paper Supply].
Reduce/Enlarge
Set the default value for [Reduce/Enlarge] in the [Copy] screen.
Select the ratio from [100%], [Auto %], and the buttons registered as R/E Preset buttons.
When the default setting for [Paper Supply] is [Auto Paper], [Auto %] cannot be selected for
[Reduce/Enlarge].
For information about R/E Preset buttons, refer to Reduce/Enlarge Presets (P.298).
Original Type
Set the default value for [Original Type] in the [Image Quality] screen.
Lighten/Darken
Set the default value for [Lighten/Darken] of [Image Options] in the [Image Quality] screen.
Sharpness
Set the default value for [Sharpness] of [Image Options] in the [Image Quality] screen.
To Next Page
Loading...
Need help?
General
