11 System Settings
302
System Settings
11
Kerberos Server Settings
Configure the Kerberos server settings.
îš„Primary Server Setup
Select the primary server specification method from [By IP Address] and [By Server Name].
îš„Primary Server IP Address
Enter the primary server IP address using values from 0 to 255.
Note • You can set this item when [Primary Server Setup] is [By IP Address].
• 224.XXX.XXX.XXX through 255.XXX.XXX.XXX, and 127.XXX.XXX.XXX cannot be set.
îš„Primary Server Name
Enter the name of the primary server. Up to 255 characters are allowed.
Note • You can set this item when [Primary Server Setup] is [By Server Name].
îš„Primary Server Port Number
Set the Primary server port number in the range from 1 to 65535.
îš„Secondary Server Setup
Select the secondary server specification method from [By IP Address] and [By Server
Name].
îš„Secondary Server IP Address
Enter the secondary server IP address using values from 0 to 255.
Note • You can set this item when [Secondary Server Setup] is [By IP Address].
• 224.XXX.XXX.XXX through 255.XXX.XXX.XXX, and 127.XXX.XXX.XXX cannot be set.
îš„Secondary Server Name
Enter the name of the secondary server. Up to 255 characters are allowed.
Note • You can set this item when [Secondary Server Setup] is [By Server Name].
îš„Secondary Server Port Number
Set the secondary server port number in the range from 1 to 65535.
îš„Realm Name
When using Active Directory of Windows 2000 Server or Windows Server 2003, set the
domain name of Active Directory in [Realm Name]. Up to 64 characters are allowed.
Important • Enter a realm name with capital letters. Otherwise, an authentication error occurs.
LDAP Server/Directory Service
Configure the directory server, authentication method, and search attributes and ranges for
LDAP authentication and address book search by LDAP.
îš„Primary Server Setup
Select the primary server specification method from [By IP Address] and [By Server Name].
îš„Primary Server IP Address
Enter the primary server IP address using values from 0 to 255.
Note • You can set this item when [Primary Server Setup] is [By IP Address].
• 224.XXX.XXX.XXX through 255.XXX.XXX.XXX, and 127.XXX.XXX.XXX cannot be set.
îš„Primary Server Name
Enter the name of the primary server. Up to 64 characters are allowed.
Note • You can set this item when [Primary Server Setup] is [By IP Address].
îš„Primary Server Port Number
Set the primary server port number in the range from 1 to 65535.
îš„Secondary Server Setup
Select the secondary server specification method from [By IP Address] and [By Server
Name].
To Next Page
Loading...
Need help?
General
