Power Saver Mode
39
Product Overview
2
Power Saver Mode
The machine is installed with a Power Saver feature that will automatically cut off the
electricity to the machine if no copy or print data is received for a certain duration.
The Power Saver feature has two modes: [Low Power mode] and [Sleep mode].
The machine enters the Low Power mode if the machine is left unused for a certain
period of time.
The machine then enters the Sleep mode after a further period of inactivity.
îš„Low Power mode
In this mode, the power to the control panel and fuser unit is lowered to save power.
The touch screen goe
s out, and the <Powe
r Saver> button on
the control pane
l lights.
To use the machine, press the <Power Saver> button. The <Power Saver> button goes
out to indicate that the Power Saver feature is cancelled.
îš„Sleep Mode
In this mode, the power is lowered more than in the Low Power mode.
The touch screen goe
s out, and the <Powe
r Saver> button on
the control pane
l lights.
To use the machine, press the <Power Saver> button. The <Power Saver> button goes
out to indicate that the Power Saver feature is cancelled.
Changing the Power Saver Mode Change Interval
The procedure for setting the Power Saver feature is as follows.
To activate the Power Saver feature, set both the times until the activation of Low
Power Mode and Sleep Mode.
1 Press the <Log In/Out> button.
2 Enter the user ID with the numeric
keypad, and select [Confirm].
Note • The default User ID is
"11111". When using the
Authentication feature, a
passcode is required. The
default passcode is "x-admin".
3 Select [System Settings].
123
456
789
0 #
C
<Log In/Out>
button
To Next Page
Loading...
Need help?
General
