5 Tools
110
Tools
5
System Settings Procedure
To change or customize the system settings, enter the System Administration mode.
This section describes the basic procedures for system settings. The following shows the
reference section for each procedure.
Step 1 Entering System Administration Mode ..................................................................................................................... 110
Step 2 Entering the System Administrator User ID and Passcode .................................................................................. 110
Step 3 Selecting [Tools].............................................................................................................................................................. 111
Step 4 Selecting a Setting Item on the [Tools] Screen ....................................................................................................... 111
Step 5 Setting a Feature ............................................................................................................................................................ 113
Step 6 Exiting System Administration Mode ........................................................................................................................ 113
Step 1 Entering System Administration Mode
1
Press the <Log In/Out> button or the login
information field on the touch screen.
Step 2 Entering the System Administrator User ID and Passcode
To enter the System Administration mode, enter the system administrator’s user ID. If
[Passcode Entry for Control Panel Login] is set to [On] under [Tools] > [Authentication/
Security Settings] > [Authentication] > [Passcode Policy], you need to enter the passcode.
We recommend that you change the system administrator’s user ID and passcode
immediately after installing the machine.
For more information on how to change the passcode, refer to "System Administrator Settings" (P.283).
1
Enter the system administrator's user ID with
the numeric keypad or the keyboard displayed
on the screen, and select [Enter].
When a passcode is required, select [Next] and
enter the system administrator's passcode, and
then select [Enter].
Note • The default user ID is "11111".
• The default passcode is "x-admin".
• The screen may differ depending on the settings of the machine.
• The <Log In/Out> button is lit when the machine enters the System Administration mode.
123
4
56
789
0#
C
To Next Page
Loading...
Need help?
General
